Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
/Page-2128007.png)
-
Insert the bonded rubber mounting so that the cut-out -arrow- faces the marking -1 -
The eccentric hole -B- in bonded rubber mounting must point forward -arrow A-.
-
Now put bonded rubber mounting and special tool into position.
Note: Use lubricant to press in the bonded rubber mounting e.g. lubricant G 294 421 A 1
CAUTION: Make sure the bonded rubber mounting does not bend when pulling in otherwise the aluminum washer may be damaged!
-
Pull in the bonded rubber mounting until the chamfer-arrows- Is positioned before the mounting hole.
-
Check that the chamfer of the outer ring is positioned evenly. Correct installation position again if necessary.
-
Slowly pull bonded rubber mounting completely in.
The tools and the bonded rubber mounting must be guided by a second mechanic when pulling in.
