Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
Alignment: Service and Repair
Rear Camber
Rear axle camber (vehicles with all-wheel drive), adjusting
-
Loosen hex nut -1-.
Note: The maximum adjustment range of the adjustment screw is 90° to the left or right of center.
-
Turn eccentric bolt until the specification is obtained.
-
Tighten hex nut -1- again, Refer to Axle/ Hub Carrier, Rear axle with four wheel drive, assembly overview, See - item 19.
-
Now check camber values again.
Specifications for vehicle alignment, Refer to Alignment Specifications