Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
-
Remove nut -1
-
Do not loosen bolts -3- and -4-.
-
Set main body -1- on the wheel bearing housing. Recesses must engage under the joints of the links.
Note: When positioning the main body, make sure that the sealing boots of the links are not damaged.
-
Main body -1- must be positioned so that bolt end is centered in drilling of main body.
-
Screw adapter -2- into main body -1- to stop so that the main body is locked in position.
-
Screw threaded sleeve -4- into main body -1- to stop.
-
Insert thrust rod -5- in threaded sleeve -4-.
-
Screw nut -8- onto threaded sleeve -4- and turn to stop so that bolt is pressed out.