Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
Pulling bearing inner race off hub
-
Install separating device -1- behind bearing inner race -2-.
Installing position: Chamfer on plates faces to bearing inner race.
-
Install support -3- and hollow piston cylinder -4- with pull rod, screw on special nut -5- and pull off bearing inner race.
1. Separating device Kukko 17/2
2. Bearing inner race
3. Support E-40
4. Hollow piston cylinder HKZ-15
5. Special nut E-8-214 and pull rod
Pressing in wheel bearing
Installation position: The larger internal diameter of the wheel bearing faces outward.
-
Install wheel bearing -1-, press piece -2- (install with collar in bearing) and hollow-piston cylinder -3- with pull rod on wheel bearing housing.
-
Install press piece -4- with chamfers to wheel bearing housing and special nut -5- on inside.
-
Press wheel bearing in by operating the pump.
1. Wheel bearing
2. Press piece E-45
3. Hollow-piston cylinder HKZ-15
4. Press piece E-43
5. Special nut E-8-214 and pull rod
Pressing in wheel hub
-
Install hub -1- and hollow-piston cylinder -2- with pull rod on wheel bearing.
-
Install press piece -3- with shoulder to special nut -4- on inside.
-
Press in hub by operating the pump.
1. Hub
2. Hollow-piston cylinder HKZ-15
3. Press piece E-5