Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
/Page-1291005.png)
-
Press grooved ball bearing out of bearing bracket.
Installing grooved ball bearing
-
Press new grooved ball bearing into bearing bracket.
Installing oil seal
-
Apply gear oil to circumference and sealing lips of seal.
-
Half fill space between sealing lip and dust lip with grease G 052 128 A1.
-
Drive new seal in until press piece makes contact; take care to keep seal straight.
Installation position:
Lugs on drive gear must engage in slots on flange shaft.
