Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
Wheel Bearing: Service and Repair
Rear
Wheel Bearing, Servicing
Wheel Bearing, Servicing
Wheel bearing/wheel hub, removing and installing
Removing
-
Remove wheel.
-
Remove securing bolts -arrows- from brake caliper housing while counter-holding on guide pins.
-
Take off brake caliper housing and secure with wire so that the weight of the brake caliper does not stress or damage the brake hose.
-
Remove brake pads.
-
Take off disc brake.
-
Remove bolts -arrows- for wheel bearing/wheel hub unit.
-
Remove wheel bearing/wheel hub unit.
Installing
Install in reverse order.
-
Install wheel and tighten.
Tightening torques:
Wheel bearing to rear axle, Refer to Axle/Hub Carrier, Service and Repair, Procedures, Rear Axle With Four Wheel Drive, Assembly Overview, See
item 3
Removing and Installing
Rear Wheel Bearing, Removing and Installing (Steel)
Special tools and equipment required