Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
-
Always replace
-
Remove before removing the ball stop
-
Fitting position: the rounded side faces to ball housing (item 20)
19. Buffer
20. Ball housing
21. Rear push rod
22. Hexagon socket head bolt, 10 Nm
23. Hexagon socket head bolt, 25 Nm
24. Washer
25. Shift lever housing
26. Hexagon nut, 10 Nm
27. Hexagon nut, 10 Nm
-
Self-locking
-
Always replace
28. Selector fork
29. Bolt
30. Tensioning ring
31. Bellows
-
Remove catalyst and front heat shield before removing and installing
Notes: Carefully pull bellows over selector rod
-
Place bellows on the marks on selector rod and push rod
32. Selector rod
-
With selector joint
33. Clamping piece
34. Hexagon socket head bolt, 25 Nm
35. Hexagon bolt, 23 Nm
-
Self-locking
-
Always replace
36. Hexagon socket head bolt, 40 Nm
37. Washer
-
The convex side faces to push rod
38. Washer
39. Front push rod
Fig. 1 Separating cover from shift lever knob
-
Turn cover inside out.
-
Carefully lever segment with a screwdriver in direction of arrow; at the same time pull the shift lever knob out.
Selector mechanism, removing and installing
Removing
-
Carefully lever the cover off the center console.
-
Then unscrew the shift lever knob with cover.