Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
/Page-2422003.png)
-
Using tube - 1 -, guide in cutting thread between lip and window flange (if cutting cord breaks, a cutting cable can also be used).
-
For very narrow gap dimensions, guide cutting cord from outside and press under lip using plastic wedge.
-
Place cutting cord around window as shown.
NOTE: Press in cutting cord far enough to prevent damage to lip/spacer.
-
Pull through outer cord end inward and counterhold using Pulling grip V.A.G 1351/1.
-
Secure inner cord end to Spooling tool V.A.G 1654.
-
Position Spooling tool V.A.G 1654.
-
Move Spooling tool V.A.G 1654 according to position required and cut windshield free.
-
While cutting free, press cutting cord against window using plastic wedge in order to have clearance from window flange.
-
In place of Spooling tool V.A.G 1654, Spooling tool V.A.G 1654 A can also be used.
-
As shown in illustration, one suction cup can be removed from Spooling tool V.A.G 1654. By doing this, roller of Spooling tool V.A.G 1654 A
can be placed closer to window flange.
Rear Window, Assembly Overview
Rear Window, Assembly Overview
