Volkswagen Workshop Service and Repair Manuals

Panel must be installed in "0 position" (panel closed).

0 position:

→ Pin -3- must be within the marks (notches) -arrow-.

Locating hooks -4- must be located in the guide rails.

If this is not the case, adjust parallel running .

• ‒ Place sliding/tilting roof on from above and screw in securing screws (link/panel).
• ‒ Lightly tighten securing screws (Torx T 25).

Notes:

• ◆ When tightening the Torx screws -1-, be sure that the adjusting plate is properly seated (the adjusting plates -2- are part of the link piece guide.)
• ◆ Tighten securing screws after adjusting glass panel height (6 Nm).