volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing sliding/tilting roof glass panel > < Sliding/tilting roof with glass panel > 09.99

Polo Mk3

General body repairs, exterior
Sliding/tilting roof with glass panel > 09.99
Sliding/tilting roof with glass panel - Assembly overview
  • Glass panel for sliding/tilting roof (single pane safety glass)
    • ◆ Removing sliding/tilting roof glass panel
    • ◆ Installing sliding/tilting roof glass panel => Page 60-7
    • ◆ Adjusting sliding/tilting roof glass panel => Page 60-11
  • Panel seal
    • ◆ Adjusting panel seal => Page 60-6
    • ◆ Seal joint is in centre of right side section
    • ◆ Treat panel seal clamping channel with water as lubricant before fitting
 
N60-0002
  • Sliding headlining
    • ◆ Removing and installing sliding headlining
  • Trim frame
    • ◆ Removing trim frame => removing sliding/tilting roof glass panel
  • Carrier unit
    • ◆ Removing carrier unit
    • ◆ Carrier unit consists of the following parts:
    • ◆ U frame with guide channels, if required, guide channels are to be greased with special grease G 000 450 02 only, otherwise correct operation cannot be guaranteed.
    • ◆ Multi-purpose grease must not be used under any circumstances.
    • ◆ Rear guides with cables
    • ◆ Front guides
 
N60-0002
  • Hand crank
  • Wind deflector
    • ◆ Open panel to rear and unscrew wind deflector
  • Threaded formed piece
    • ◆ Thread must be at an angle to rear
  • Wind deflector securing screws
  • Manual drive unit cover
  • Drive unit (manual)
  • Countersunk screws (micro encapsulated)
    • ◆ Always use new countersunk screws
    • ◆ 3 Nm
 
N60-0002
  • Locating hook
  • Locating hook spring
  • Torx screw
    • ◆ Torx key T 25
    • ◆ 6 Nm
  • Adjusting plate
    • ◆ Part of link piece guide
  • Water drain hose
    • ◆ Cleaning water drain hose => Page 60-16

Removing sliding/tilting roof glass panel > < Sliding/tilting roof with glass panel > 09.99