volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing parts of ABS system on front axle, VW II brake caliper > < Removing

Polo Mk3

Contact assignment of T25 connector for wiring harness/control unit J104
   
Contact assignment of -T25- connector for wiring harness/control unit -J104-
  N45-0037
ContactWiring connection to component ...
19 + 20Front right speed sensor -G45-
1 + 2Front left speed sensor -G47-

   
–  Push out relevant contacts with an ejector tool from wiring harness repair set -VAS 1978-.
–  Unplug connector on speed sensor wire and speed sensor.
–  Remove defective speed sensor wiring and guide in new speed sensor wiring.
–  Connect speed sensor to speed sensor wiring.
  A45-0051
–  Clip in speed sensor wiring -arrow-.
Ensure the wiring is not twisted when installing the speed sensor wiring in the wheel housing.
–  Guide contacts into connector housing.
  N45-0159
–  Push individual wiring seals in onto stop with an insertion tool from-VAS 1978-.
–  Secure contacts with secondary locking device and fit cover cap for multi-pin connector.
  A45-0047

Removing and installing parts of ABS system on front axle, VW II brake caliper > < Removing