Polo Mk3
|
Note| Parts marked “*” can be repaired only in workshops with suitable equipment and specially trained mechanics because the refrigerant must be evacuated beforehand using, for example, the air conditioning service station -VAS 6007A-. |
| 1 - | Air duct |
| 2 - | Dust and pollen filter |
| q | In plenum chamber. |
| q | With active charcoal filter. |
| q | Removing and installing → Chapter. |
| 3 - | Heating and air conditioning controls |
| q | With built-in air conditioning system switch -E30-. |
| q | With fresh air blower switch -E9-. |
| q | With fresh air and air recirculation flap switch -E159-. |
| q | Removing and installing → Chapter. |
| q | Dismantling and assembling → Chapter. |
| 4 - | Dash panel |
| q | Removing and installing → Rep. Gr.70. |
| 5 - | Vent on front passenger side |
| q | Removing vent → Chapter. |
| 6 - | Fresh air and air recirculation flap control motor -V154- |
| q | Removing and installing → Chapter. |
| 7 - | Fresh air blower -V2- |
| q | Removing → Chapter. |
| 8 - | Fresh air blower series resistor with overheating fuse -N24- |
| q | Removing → Chapter. |
| 9 - | Central vents |
| q | Removing vent → Chapter. |
| 10 - | Heater and air conditioner* |
| q | Removing → Chapter. |
| q | Dismantling and assembling evaporator housing → Chapter. |
| 11 - | Cables |
| q | Installing and adjusting → Chapter. |
| 12 - | Connecting piece |
| 13 - | Cover |
| 14 - | Footwell vent |
| q | Removing vent → Chapter. |
| 15 - | Footwell system |
| 16 - | Intermediate piece, defrost |
| q | To renew, remove and install dash panel → Rep. Gr.70. |
| 17 - | Heat exchanger* |
| q | Removing → Chapter. |
| 18 - | Heat exchanger/bulkhead seal* |
| q | Removing → Chapter. |
| q | Note installation position → Chapter. |
| 19 - | Vent on driver side |
| q | Removing vent → Chapter. |
