Volkswagen Workshop Service and Repair Manuals

→ I = New:

The protective boot -1- for the automatic adjustment is now located behind the adjusting device -2-. The clutch cable is supported with a wire retainer -3-.

II = Previously:

The protective boot -1- for the automatic adjustment is located in front of the adjustment device -2-. The clutch cable is supported in a sheet metal retainer -3-.

Making clutch cable adjusting mechanism serviceable again (from 27.04.95).

• ‒ A functional check of the new clutch cable is to be carried out as previously described on page 30-5 .
• ‒ → Pull clutch cable out of fork in release lever by pulling forcefully (direction of arrow).
• ‒ Pull rubber buffer out of support bracket on gearbox.

• ‒ → Move braiding -A- of cable to and fro several times, until the adjusting mechanism -B- can be pressed together.
• ‒ Tension clutch cable with retaining strap =>from page 30-18 .
• ‒ Press rubber buffer into support bracket on gearbox.
• ‒ Connect clutch cable to release lever.
• ‒ After installing clutch pedal remove retaining strap.
• ‒ Carry out functional check again.