Volkswagen Workshop Service and Repair Manuals

Special tools, workshop equipment, testers, measuring instruments and auxiliary items required

• ◆ Depth gauge
• ◆ Valve seat refacing tool

Notes:

• ◆ When repairing engines with leaking valves, it is not sufficient to replace or renew valve seats and valves. It is also necessary to check the valve guides for wear. This particularly important on high mileage engines .
• ◆ The valve seats should only be reworked just enough to produce a perfect seating pattern. The maximum permissible reworking dimension must be calculated before work is carried out. If the reworking dimension is exceeded, the function of the hydraulic tappets can no longer be guaranteed and therefore the cylinder head should be renewed.

The max. permissible reworking dimension is calculated as follows:

• ‒ Insert valve and press firmly against seat.

Note:

If the valve is to be renewed as part of a repair, use a new valve for the calculation.

• ‒ → Measure distance -a- between end of valve stem and upper edge of cylinder head.
• ‒ Calculate max. permissible reworking dimension from measured distance and minimum dimension.

Minimum dimension:
     Inlet valve and outlet valve 32.1 mm

Measured distance minus minimum dimension
= max. permissible reworking dimension.

Example:

     *)     The max. permissible reworking dimension is shown on illustrations for reworking valve seats as dimension "b".

→ Reworking inlet valve seat

Note:

Valve seat rings having restrictor may only be reworked so far that the restrictor is not damaged.

→ Reworking exhaust valve seat