Polo Mk3
|
General to self-diagnosis
Features of self-diagnosis
The 4CV injection and ignition system control unit (J448) is equipped with a fault memory. If faults occur in the sensors and components being monitored, they will be stored in the fault memory together with an indication of the type of fault. After evaluating the information, the engine control unit decides among different faults => Fault table Page 01-34 and stores these until the contents of the fault memory is erased. Faults which only occur sporadically will have the addendum "sporadic fault" on the print out. These faults will be indicated on the display by the addendum "/SP". The cause of sporadic faults can be e.g. a loose contact or a brief open circuit. If a sporadic fault does not occur again within 40 warm-up phases (engine start below 50° C coolant temperature - switched off above 72° C), it will be erased from the fault memory. The faults stored can be read-out with the fault reader V.A.G 1551, the vehicle system tester V.A.G 1552 or the new tester VAS 5051 . The fault memory must be erased after the faults have been rectified => Page 01-13 . Note: General information for self-diagnosis can be found in the instruction manuals for the fault reader V.A.G 1551, vehicle system tester V.A.G 1552 or the new tester VAS 5051. |
