Volkswagen Workshop Service and Repair Manuals > Polo Mk3 > Vehicle electrics | Electrical system | Wiring | Removing and installing relay carrier, coupling station and fuse holder | Removing and installing multi-pin connector on back of relay plate, vehicle ? 1997

Removing and installing multi-pin connector on back of relay plate, vehicle ▸ 1997

Removing and installing multi-pin connector on back of relay plate, vehicle ► 1997

Note

Remove multi-pin connector:

–	Disconnect battery → Chapter.

–	Pull locking slide -1- on back of relay plate out of housing onto stop (approx. 5 mm) -arrow-.

–	Press fasteners on multi-pin connector -arrow- and pull multi-pin connector out of relay plate.

Install multi-pin connector:

Note

Insert multi-pin connector so that the locking pins -2- face towards the locking slide -1-.

–	Insert multi-pin connector into respective slot onto stop so that locking pin -2- is inserted into cut-out -4- and press inwards until locking lug -3- engages.

–	Press locking slide -1- onto stop -arrow-. This is only possible when all multi-pin connectors are installed so that each locking lug -3- is inserted and engaged.

–	Connecting battery → Chapter.

Volkswagen Workshop Service and Repair Manuals