volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing multi-pin connector on back of relay plate, vehicle ? 1997 > < Removing and installing relay carrier, coupling station and fuse holder

Polo Mk3

Removing and installing relay plate, vehicles ▸ 1997
Removing and installing relay plate, vehicles ► 1997
Removing:
–  Disconnect battery → Chapter.
–  Remove driver side storage compartment → General body repairs, interior; Rep. Gr.68.
   
–  Release securing clips -1- from pins -3- on left and right of relay plate and swing upwards.
–  Press left retaining arm -2- outwards, until the locking device on the relay plate is pulled out of the hole -4- of the retaining arm. Then unhook relay plate.
Installing:
Installation is carried out in the reverse order. When installing observe the following:
When installing, ensure the relay plate locking device engages in the hole -4- of the retaining arm. The securing clips -1- engage on the pins -3-.
  N97-0003

Removing and installing multi-pin connector on back of relay plate, vehicle ? 1997 > < Removing and installing relay carrier, coupling station and fuse holder