volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Erasing fault memory > < Reading control unit version

Polo Mk3

Reading fault memory
Reading fault memory
  Note
The following sequence is described for the fault reader -V.A.G 1551-, the sequence described in the chapter for the “vehicle diagnosis, testing and information system may also be used” → Chapter.
–  Initiating self-diagnosis of data bus diagnostic interface -J533- → Chapter.
  Note
The displayed fault information is only updated when the self-diagnosis is started or the function 05 “Erase fault memory” is selected. The information is not continuously updated.
–  Switch on the printer with the PRINT key (indicator lamp in key lights up).
   
Indicated on display:
–  Press keys 0 and 2. (02 selects the function “Read fault memory”).
  
Rapid data transfer                 HELP
Select function XX
Indicated on display:
–  Confirm entry with Q key.
  
Rapid data transfer                    Q
02 - Read fault memory
The number of stored faults appears in the display.
The stored faults are displayed and printed out one after another.
–  Check print out against fault table and rectify all faults as necessary → Chapter.
  Note
  
X faults recognized!                    

      

      

    
      

      

    
If “No fault recognised” is displayed the programme will return to the start point after pressing → key.

      		 
      
    
No fault recognized!                  ->

      

      

    
      

      

    
Indicated on display:
If something else is displayed:  → Fault reader operating instructions.
– 
          End output (function 06)  → Chapter.

      		 
      
    
No fault recognized!                  ->
Rapid data transfer                 HELP
Select function XX                      

      

      

    


Erasing fault memory >
< Reading control unit version