volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Assemble > < Assembly overview

Polo Mk4

Remove
   
Remove

–  Remove the operating lever → Chapter.
–  Remove the lower pillar A covering on the left side → Body - Internal assembly works; Rep. Gr.70
–  Disengage the on-board network command and keep it under the pedals → Electrical system; Rep. Gr.97
–  Disengage the fuse holder and the relay holder and move them inside the instrument panel → Electrical system; Rep. Gr.97.
–  Remove the windscreen washer system → Electrical equipment; Rep. Gr.92
–  Disengage the bonnet latch operating cable -1- from the support bracket -7- and from the front bonnet latch -10-.
–  Disengage the bellows -2- and the bellows -4- from the engine compartment partition panel, as well as the front bonnet latch operating cable -1- from the clip -3- and the supports -9-.
–  Remove the front bonnet latch operating cable -1- from inside the engine compartment.
–  Place the bellows -2- and -4- on the new front bonnet latch operating cable.
  Note
Make sure that the bellows is properly seated, to avoid leaks.
   

Assemble > < Assembly overview