volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Front subframe - remove and install|Install > < Front subframe - remove and install

Polo Mk4

Remove
Remove
   
–  Remove the front door lining → General body repairs, interior; Rep. Gr.70
–  Remove the latch cylinder → Chapter.
  N57-0214
–  Remove the clip -1- from the door handle.
–  Remove the plugs -1-.
  Note
If the window drive mechanism motor is not operating, preventing the door window from being lowered, remove the electric motor so the window lowers.
–  Lower the door window until the door window fastening screws -2- are accessible.
–  Remove the screws -2- and separate the tightening jaws.
  N57-0403
–  Move the door window upwards and fasten (for example, with adhesive tape).
  N57-0404
–  Disconnect the electric connectors -arrows-.
–  Loosen the screws -2-.
  N57-0401
–  Tightening torque: Screws -2- = 20 Nm
–  Loosen the screws -arrows-. Pull the door subframe upwards, raise and remove from the door hinge side.
–  Turn the subframe and disconnect the connector from the door lock.
–  Disengage the clips from the electric harnesses on the back side of the subframe.
  N57-0427

Front subframe - remove and install|Install > < Front subframe - remove and install