Polo Mk4
| Rear door window (sedan) - assembly overview |
| 1 - | Door |
| q | Remove and install → Chapter |
| 2 - | Screw |
| q | 2 Nm |
| q | 2 parts |
| q | in assembly, initially tighten the upper screw and, then, the lower screw |
| 3 - | External door lining |
| q | In assembly, first tighten the screws - → Item- on the front section of the door and, then, tighten the screws - → Item- in the sequence established |
| 4 - | Screw |
| q | 2 Nm |
| q | 2 parts |
| q | in assembly, initially tighten the upper screw and, then, the lower screw |
| 5 - | Clip |
| 6 - | Intermediate segment |
| 7 - | Fixed door window |
| q | Firmly connected to the external door lining - → Item- |
| 8 - | Door window groove |
| q | Fitted over the flange and fastened inside the door |
| q | for “Confortline” finish, with longer front edge |
| 9 - | External window packing |
| q | Fitted to the flange |
| q | Firmly connected to the fixed door window - → Item- |
| 10 - | Door window |
| q | Remove → Chapter |
| q | Assemble the door window to the window drive mechanism |
| 11 - | Screw |
| q | 6 Nm |
| 12 - | Cover cap |
| 13 - | Subframe |
| q | Remove and install → Chapter |
| q | The window drive mechanism is part of the subframe |
| 14 - | Internal window packing |
| q | Fitted to the flange |
| 15 - | Window drive mechanism |
| q | Is assembled from behind, on the subframe |
| q | The window drive mechanism motor is fastened from the front section to the subframe |
| q | Remove the window drive mechanism motor → Chapter. |
