–
| Support the assembly unit -1- on the rear housings and turn upwards. |
Note The fastening pins must be in the assembly holes. |
–
| Align the assembly unit -1- during assembly, by using two cylindrical pins (drill bits turned to the contrary), in the right side -2- 10 mm and left side -6- 12 mm, in the roof. |
–
| Check the installation of cables and connectors of the power consumers in the roof, and if necessary, establish the connection. |
–
| Fasten the assembly unit -1- of the sliding / tilting sunroof drive -4-, starting from the left and right sides, and moving backwards (8 Nm). |
–
| Insert connector -5-in the motor -4-.. |
–
| Install the water draining hoses -arrows-. |
–
| Install the sliding / tilting sunroof glass pane → Chapter. |
|
|
|