volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Draining hoses - clean > < Assembly unit - remove and install|Installation

Polo Mk4

Guide with steel cable - remove
Guide with steel cable - remove
–  Remove the sliding / tilting sunroof glass pane → Chapter.
–  Remove assembly unit → Chapter.
   
–  Remove the sliding / tilting sunroof drive → Chapter
–  Disconnect tip -1- on the guide slides -2--arrows-, and then, remove.
  Note
When installing, seal the tip -1- with Butyl adhesive cord -AKL 450 005 05- on the opposite side of the guide rail.
  N60-0116
–  Release carefully the water gutter -1- by using a screwdriver on both sides of the support, in the coupling hook guide -2- and remove.
  N60-0117
–  Move the guide with steel cable -1- towards arrow, on guide rail -4-, until releasing the coupling hook guide lock -3-.
–  Pull the guide with steel cable -1-, coupling hook guide -3- and slide guide -2- outwards, with the guide rail -4-.
Assembly notes
t  Always replace the guides with steel cables in pairs.
t  Lubricate the guide channels with special grease -G 000 450 02-
t  Install the assembly unit → Chapter.
t  Adjust the parallelism → Chapter.
t  Install the sliding / tilting sunroof glass pane → Chapter.
  N60-0118

Draining hoses - clean > < Assembly unit - remove and install|Installation