Polo Mk4
Sliding / tilting roof with glass pane - assembly overview |
1 - | Glass pane for sliding/tilting sunroof (single laminate safety glass) |
q | Remove the glass pane for the sliding/tilting sunroof → Chapter |
q | Install the glass pane for the sliding/tilting sunroof → Chapter |
q | Adjust the glass pane for the sliding/tilting sunroof → Chapter |
2 - | Cover packing |
q | Adjust sunroof packing → Chapter |
q | The packing ends are turned to the centre, on the rear part. |
q | Replace the sunroof packing → Chapter |
3 - | Solar protective coating |
q | Remove and install → Chapter |
4 - | Screw |
q | 1.5 Nm |
5 - | Sliding |
6 - | Lower frame |
7 - | Water gutter |
q | Remove → Chapter, the guide with steel cable |
8 - | Guide with coupling hook |
9 - | Tip |
q | for sealing, use Butyl adhesive cord -AKL 450 005 05- |
10 - | Guide frame |
q | Remove and install guide frame → Chapter |
q | When required, lubricate the guide channels with special grease -G 000 450 02-. Otherwise, the operation is not assured. |
11 - | Screw |
q | 3,5 Nm |
q | Must always be replaced upon removal |
12 - | The hexagonal wrench for emergency actuation |
q | is fitted on the cover of the sliding sunroof drive motor |
13 - | Control unit for sliding sunroof displacement -J245- |
q | Remove → Chapter |
q | The sunroof sliding adjustment -E139- is fitted in the control unit. |
q | Remove the sunroof sliding adjustment -E139- → Chapter |
14 - | Siding sunroof drive motor -V1- |
q | Remove → Chapter |
q | Adjust the motor (position zero) → Chapter |
15 - | Spring |
16 - | Air deflector |
q | Remove → Chapter |
17 - | Torx screw |
q | T 25 |
q | 4.5 Nm |
18 - | Guide with steel cable |
q | Remove → Chapter |
19 - | Slide guide |
q | Remove → Chapter |
20 - | Spacer |
21 - | Bellows |
q | Remove → Chapter |
q | Install → Chapter |