volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Connector of the airbag coil and return spring with sliding ringF138 - remove and install|Installation > < Connector of the airbag coil and return spring with sliding ringF138 - remove and install

Polo Mk4

Removal
Removal
Vehicles with (3 spokes steering wheel):
–  Remove the Ignition device for the driver's airbag -N95- → Chapter.
–  Remove the steering wheel → Chassis, axles, steering; Rep. gr.48.
Vehicles with (multifunction steering wheel):
–  Remove the Ignition device for the driver's airbag -N95- → Chapter.
–  Remove the steering wheel → Chassis, axles, steering; Rep. gr.48.
Vehicles with (spoked steering wheel):
–  Remove the Ignition device for the driver's airbag -N95- → Chapter.
–  Remove the steering wheel → Chassis, axles, steering; Rep. gr.48.
  WARNING
While removing and installing the Airbag coil connector and return spring with sliding ring -F138- , make sure that the connector is at the intermediate position (wheels facing forward - aligned).
   
–  Detach the locks -arrows- (from the upper and lower parts) of the Connector of the airbag coil and return spring with sliding ring -F138--1- and remove it from the turn signal and windshield lever.
  R69-10081

Connector of the airbag coil and return spring with sliding ringF138 - remove and install|Installation > < Connector of the airbag coil and return spring with sliding ringF138 - remove and install