volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Ignition device for driver's airbagN95 (multifunction steering wheel) - removal and installation > < Ignition device for driver's airbagN95 (steering wheel with 3 spokes) - removal and installation|Removal

Polo Mk4

Installation
Installation
The installation occurs in the reversal sequence of removal, observing the following instructions:
  Caution
The electrostatic discharges can cause an involuntary firing of the airbag. That's why the assembler should perform the electrostatic discharging before connecting the ignition cable and the mass cable. This can be done, for instance, by touching the vehicle's door lock stop.
   
–  Connect the connector -1- to the ignition device for the driver's airbag -N95--2-.
  R69-10064
–  Connect connector -1- from the steering wheel -3-.
–  Place the ignition device for the driver's airbag -N95--2-in the installation position and press it inwards to the steering wheel-3- until the engaging is heard in both sides.
Assembly notes:
t  Turn off all electrical devices.
t  Turn on the ignition.
t  Connect the battery's mass cable → Electrical equipment ; Rep. gr.27.
  WARNING
When connecting the battery's mass cable, make sure that no one is inside the vehicle.
  R69-10063

Ignition device for driver's airbagN95 (multifunction steering wheel) - removal and installation > < Ignition device for driver's airbagN95 (steering wheel with 3 spokes) - removal and installation|Removal