The installation occurs in the reversal sequence of removal,
observing the following instructions: |
–
| Install the lower covering -3-. |
Observe the tightening sequence of fastening screws on the
steering wheel covering: |
–
| Tighten fastening screws -2- to (1.5 Nm)
torque. |
–
| Screw on the fastening screw -4- with torque
of (3.5 Nm). |
–
| Fit the upper covering -1- on lower covering -3-, according to the detail. |
WARNING When connecting the battery's mass cable, make sure that
no one is inside the vehicle. |
|
|
|
|