Volkswagen Workshop Service and Repair Manuals

Reverse shaft - dismantle and assemble

Special tools and workshop equipment required

t	Pressure tube -VW 454-

t	Pressure disc -VW 447 H-

t	Pressure pin -VW 411-

t	Centralizer -12-551-

t	Plate -VW 401-

t	Pressure pin -VW 408A-

t  Inner puller -Kukko 21/6- t  Counter-support -KUKKO 22/2-   Note After dismantling, always renew needle roller bearing in clutch housing and reverse shaft support

1 -	Clutch housing

2 -	Needle roller bearing

q	Remove → Fig.

q	Install → Fig.

3 -	Reverse gear wheel

4 -

Circlip

q	Always renew after removing.

5 -	Reverse gear wheel

q	Before replacing remove circlip.

q	Shoulder faces to reverse gear wheel.

6 -	Reverse shaft

q	Remove → Chapter

7 -	Needle roller bearing

q	Remove → Fig.

q	Install → Fig.

8 -	Reverse shaft support

q	Remove and install → Chapter

Pull needle roller bearing out of clutch housing A - Counter support, e.g. -Kukko 22/1- B - Internal puller 14.5 ... 18.5 mm, e.g.- Kukko 21/2-   Note The needle bearing is destroyed during removal and must be renewed

Press needle roller bearing -A- into clutch housing

Press needle roller bearing out of the reverse shaft support

Press needle roller bearing into reverse shaft support