–
| Initially disconnect the vent hose -1- for the activated charcoal filter on the Magnetic valve 1 for the activated charcoal reservoir -N80--2-. |
–
| Then, connect the Vacuum pump - VAG 1390- or Vacuum pump -VAS 6213- and the Vacuum gauge -VAG 1368- to the hose -1-, as shown. |
–
| Place the Vacuum gauge -VAG 1368- in -A/B- position. |
–
| Operate the Vacuum pump -VAG 1390- or Vacuum pump -VAS 6213- several times. No vacuum may be generated. |
In case of vacuum formation: |
–
| Check the ventilation opening -3- at the bottom of the activated charcoal filter -4- for dirt and, if necessary, clean it. |
In case of absence of vacuum: |
–
| Cover the ventilation opening -3- and operate again the Vacuum pump -VAG 1390- or Vacuum pump -VAS 6213- several times. Vacuum must be generated. |
In case of absence of vacuum: |
–
| Replace the activated charcoal filter. |
Note If the fuel tank level is low, the Vacuum pump -VAG 1390- or Vacuum pump -VAS 6213- must be activated approximately 20...30 times. |
–
| Replace the fuel reservoir nozzle lid. |
|
|
|