Polo Mk4
Note
|
1 - | Compressor support |
Removal: |
– | Remove the power steering pump and set it aside → Chassis, Axles, Steering; Rep. gr.48. |
– | Remove the Generator (alternator) -C- → Electrical system; Rep. gr.27. |
– | Remove compressor from support and fasten it to body → Item. |
– | Remove the fastening screws and remove the engine block support. |
Installation: |
The installation occurs in the reversal sequence of removal, observing the following instructions: |
– | Observe the following fastening screw tightening sequence: |
t | First, tighten the fastening screws -3 and 5-, and then tighten the fastening screws -2 and 4- to (50 Nm). |
2 - | Screw |
q | 50 Nm. |
3 - | Screw |
q | 50 Nm. |
4 - | Screw |
q | 50 Nm. |
5 - | Screw |
q | 50 Nm. |
6 - | Bushings |
7 - | Compressor |
Removal: |
– | Remove Poly-V belt → Engine; Rep. gr.13. |
– | Remove fastening screws -8-. |
– | Remove compressor from support and fasten it to body → Fig. |
Installation: |
Installation is performed in reverse sequence to the removal, observing the following: |
– | Tighten the compressor fastening screws -8- to (23 Nm). |
– | Check Poly-V belt travel. |
Note
If it is necessary to fully remove the compressor, refer to → Chapter. |
8 - | Screw |
q | 23 Nm. |
9 - | Tensioning roller |
10 - | Tensioning element on tensioning pulley |
Note
|