Polo Mk4
|
Assembly overview of Behr plenum chamber with ventilation and heating system/Climatic: |
1 - | Harness for the heater and air conditioning equipment |
2 - | Upper part of evaporator case |
3 - | Support |
q | Fastened on the cross support and plenum chamber. |
4 - | Fresh air fan pre-resistance with overheating fuse -N24- |
q | Remove and install → Chapter. |
5 - | Evaporator/engine compartment partition panel sealing |
q | Replace if damaged. |
6 - | Expansion valve |
q | Remove and install → Chapter. |
7 - | Air intake nozzle |
q | With cold air and recirculation vents. |
8 - | Sealing |
q | Replace if damaged. |
9 - | Dust and pollen filter |
q | Remove and install → Chapter. |
10 - | Control motor for natural air valve and recirculation valve -V154- |
q | It operates simultaneously the cold air and air circulation small door. |
q | Remove and install → Chapter. |
q | Check → Chapter. |
11 - | Support |
12 - | Natural air fan -V2- |
q | Remove and install → Chapter. |
q | Check → Chapter. |
13 - | Fan case |
14 - | Lower part of evaporator case |
15 - | Dust and pollen filter cover |
16 - | Lower plenum chamber part |
17 - | Auxiliary heating resistance -Z35- |
q | Diesel engine vehicles only. |
q | Remove and install → Chapter. |
18 - | Heat exchanger |
q | Remove and install → Chapter. |
19 - | Air distribution drive mechanism |
q | Remove and install → Chapter. |
20 - | Evaporator seal |
q | Check installation position: Water drain facing down. |
21 - | Evaporator |
q | Remove and install → Chapter. |
22 - | Upper plenum chamber part |
23 - | Support |
24 - | Control motor for temperature adjustment valve -V68- |
q | Remove and install → Chapter. |
q | Check → Chapter. |