| –
| Place the selector lever in the position "P". |
| –
| Place the connecting rod of the transmission selector axle in "P". The fitting lever must couple to the blocking pinion for parking, and the two front wheels are blocked (cannot turn together in one direction) |
| –
| Change the adjusting washer -1- if it was disassembled before |
| –
| Then, press the selector lever cable over the connecting rod of the selection axle. |
| –
| → Tighten the screw -2- (8 Nm). |
| –
| Press the selector lever knob blocking key and pull the lever 5 mm backwards. Release the selector lever. |
| The selector lever must couple again by itself to the position "P". |
| –
| Place the selector lever in "N", always pull 5 mm forwards and backwards (check as in "P"). |
| The selector lever must couple again by itself to the position "N". |
| –
| With this, the adjustment is concluded. |
| –
| If necessary, repeat the adjustment again and repair the transmission activation mechanism. |
|
|
|
