| –
| Remove the left front wheel. |
| –
| Check the hydraulic fluid level and replenish, if necessary → Chapter. |
| –
| Lift the vehicle until the wheels turn freely. |
| –
| Turn the steering wheel from stop to stop 10 times, with
the engine stopped. |
| –
| Check the hydraulic fluid level and replenish, if necessary → Chapter. |
| –
| Loosen the hydraulic oil reservoir lid. Do not tighten! |
| –
| Start the engine and run for 10 seconds. |
| –
| Check the hydraulic oil level and replenish, if necessary → Chapter. |
| –
| Loosen the hydraulic oil reservoir lid. Do not tighten! |
| Repeat the following work sequence until the oil level no
longer lowers. |
| –
| Turn the steering wheel 10 times from stop to stop. |
| –
| Check the hydraulic fluid level and replenish, if necessary → Chapter. |
| –
| After the bleeding procedure is concluded, tighten the motor/pump
set reservoir lid manually. |
Note | Any residues in the steering system will escape automatically,
after driving for approximately 10 to 20 km. |
|
|
|
