Polo Mk4
Note
|
| 1 - | Steering terminal of linkage bar (right side) |
| q | Marked with „C“ → Anchor |
| q | Check → Chapter. |
| q | Observe the assembly position → Anchor. |
| 2 - | Hexagonal nut |
| q | 50 ± 5 Nm |
| 3 - | Clamp |
| 4 - | Protective bellows |
| q | Must not be twisted after adjusting the alignment |
| q | Remove the steering box to replace it |
| q | Assemble → Chapter |
| 5 - | Clamp |
| q | Fasten → Chapter |
| q | Replace - open with pliers |
| 6 - | Gasket |
| 7 - | Steering terminal of linkage bar (left side) |
| q | Marked with „D“ → Anchor |
| q | Check → Chapter. |
| q | Observe the assembly position → Anchor. |
| 8 - | Hexagonal nut |
| q | 50 ± 5 Nm |
| 9 - | Clamp |
| 10 - | Protective bellows |
| q | Must not be twisted after adjusting the alignment |
| q | Remove the steering box to replace it |
| q | Assemble → Chapter |
| 11 - | Clamp |
| q | Fasten → Chapter |
| q | Replace - open with pliers |
| 12 - | Steering linkage bar (right side) |
| q | Is supplied along with the steering box as a replacement part. |
| q | 80 ± 8 Nm |
| 13 - | Power steering box |
| q | Remove and install → Chapter |
| 14 - | Steering linkage bar (left side) |
| q | Is supplied along with the steering box as a replacement part. |
| q | 80 ± 8 Nm |
| 15 - | Rubber bearing |
| 16 - | Clamp with nuts |
| q | Replace if threads are damaged |
| 17 - | Heat shield |
| q | Only for some markets |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| 18 - | Screw |
| q | 8 Nm |
