| –
| Release the locknut -1-. |
| –
| Adjust the convergence by turning the steering bar to the
left and/or to the right. |
| –
| To do this, use a spanner on the hex head -arrow- of the steering linkage bar. |
Note | t
| After turning the steering bars, confirm if the bellows are
not twisted. |
| t
| Twisted bellows wear out quickly |
| –
| Tighten the locknut -1-. Tightening torque,
see → Anchor. |
| After tightening the locknut -1-, it is possible that the adjusted value slightly changes. |
| –
| Check the convergence value once more |
| If the convergence value measured lies within
the tolerance, the adjustment is correct. |
|
|
|
