| "CD player" -R89-„2 Din Clarion“ anti-theft system - activate |
WARNING | If you do not know the anti-theft code, query it in the ELSA
system (Specific vehicle information), by using the chassis number
of the "CD player" -R89-„2 Din Clarion“, located on the upper part of the equipment, along with the vehicle's
chassis number. |
|
| –
| Turn on the "CD player" -R89-„2 Din Clarion“. |
| The digital display will automatically show „SAFE“ and then „1000“. |
| –
| By using the station preset keys 2 to 4, insert the "CD player" -R89-„2 Din Clarion“ code
along with the equipment ID number → Radio Instruction
Manual. Use key 1 to select the first digit
of the code, use key 2 do select the second digit and so on. |
| –
| Then, press the seek key (right side), and
keep it pressed until the anti-theft code is deactivated. |
Note | If an incorrect code number is used when activating the electronic
anti-theft system, the „SAFE“ notification will begin
flashing on the display, followed by the „1000“ notification.
At this time, it is possible to repeat the entire operation. If an
incorrect code is entered again, the device will be blocked for approximately
one hour, meaning, it will non-operational during that time. A device
block is indicated on the left side of the display and permanently
shows the „SAFE“ notification and the number „2“ (small). This notification will disappear after one hour, at which
point it is possible to input the code again with the key in the ignition
and the device connected to the vehicle. The »two-attempt/one-hour
block cycle« remains valid. |
|
|
|
