Volkswagen Workshop Service and Repair Manuals > Polo Mk4 > Vehicle electrics | Communication | Infotainment | Radio R | RadioR"GAMMA" ? 12/04

RadioR„GAMMA“ - remove and install

Radio -R-„GAMMA“ - remove and install

Special tools and workshop equipment required

t	Puller -3316-

Removal:

–	Turn off the ignition, all the electrical devices, and remove the key from ignition.

–	Introduce the Puller -3316- into the housings -arrows- until they fit onto the device.

–	Remove the radio from the panel, moving it Puller -3316- towards the -arrows - and pulling it.

–	Disconnect the connector from the Radio -R-„GAMMA“ and remove the antenna cable.

–	After removing the equipment, remove each Puller -3316- by pressing the lock -arrow -.

Note

When doing this, the puller must not be bent or pressed sideways.

Installation:

–	Connect the connectors for the Radio -R-„GAMMA“ and the Antenna -R11-.

–	Install the Radio -R-„GAMMA“, by pushing it inside the housing in the dash until it fits in completely.

Note

Never press the command keys or the display during installation, otherwise the device may be damaged.

–	Activate the electronic anti-theft alarm system, if necessary → Chapter.

–	Check coding of the Radio -R-„ BETA“and, if necessary, adapt → Chapter.

Volkswagen Workshop Service and Repair Manuals