Volkswagen Workshop Service and Repair Manuals > Polo Mk4 > Vehicle electrics | Electrical system | Windscreen wipe/wash system | Windscreen washer system | Windscreen washer system washer jets - adjust | Pre-adjusted washer jets (fan-type nozzles)

Pre-adjusted washer jets (fan-type nozzles)

The washer jets are pre-adjusted, but small differences in height can be adjusted.

Note

t	If the spray jet is irregular or cannot be adjusted to the centre of the washer area, the nozzle must be replaced (repair measure) → Chapter.

t	Under no circumstances should needles or similar objects be used, since this might damage the nozzle's water passage.

t	The washer jets cannot be cleaned in the opposite direction of the jet, e.g., blowing from the front.

Nozzle jet position:

a -	491 + 76 mm

a -	491 - 190 mm

If the two action surfaces of the ejector jet are not according to the dimensions -a -, the jet height must be adjusted as explained below:

–	Adjust the jet through the nozzle tab-1- by moving it slightly with your hand, upward or downward, with the front bonnet closed.

Note

To perform the adjustment, support the ejector with your hand to prevent it from moving from the housing.

Volkswagen Workshop Service and Repair Manuals