Volkswagen Workshop Service and Repair Manuals

Main fuse holder (Version 2) - remove and install Removal:

–  Release the cover -1- from the main fuse holder by releasing the tab -arrow- from the side locks -2-. –  Push the fuse holder cover -2- up.

–  Remove the side locks -3- from the cover -2- of the main fuse holder -1- and remove the cover -2-. –  Disconnect the ground cable and the positive wire from the Battery -A- → Chapter.

–  Release the securing nut -3- (6 Nm) from the B+ cable -4- and remove it. –  Place the main fuse holder -2-, without fitting it, above the Battery -A--1-.

–  Unlock the fastening tabs -arrows- and remove the cover cap -1- from the main fuse holder -2-.

–  Release the securing nuts -1- (6 Nm) and remove the terminals-2-.

–  Unlock the fitting projection -arrow- and remove the fitting fuse holder -1- from the main fuse holder -2-.

–  Move the cable guide -2- in direction of the -arrow- to outside the main fuse holder -1- and position it until permitted by the cable length. –  Remove the main fuse holder -1- from the Battery -A-. Installation: Installation is performed in reverse sequence to the removal, considering the following: –  Tighten the securing nuts to (6 Nm).