Volkswagen Workshop Service and Repair Manuals

Main fuse holder (version 5) - remove and install Removal: –  Turn off the ignition and all electrical equipment, and remove the key from ignition. –  Disconnect the Battery -A- → Chapter.

–  Remove cover -1- with the aid of a screwdriver, unlocking the locks located at the -arrows-. –  Identify the position of the terminals for the -A- cables and remove them.

–  Remove the securing nuts -1- and the reinforcement -2-.

–  Remove multiple fuse -1-.

–  Remove side fuse housing -1-, detaching the locks according to -A arrows-, pulling it up.

–  Loosen the locks towards the -arrows- of support -1-. Installation: Installation is performed in the reverse sequence to the removal, observing the following   Note t  It is imperative that all conductors/terminals are installed back into their respective locations. t  Mount the fuses according to the Electrical Diagram → Current flow diagrams, Electrical fault finding and Fitting locations.

–  Tighten securing nuts -1- with (6 Nm) torque.