| Preparing body kit component for bonding |
| –
| Remove existing adhesive residues of double-sided adhesive tape with adhesive remains remover -VAS 6349-. |
| –
| Cut back adhesive points of PUR adhesive to about 2 - 3 mm without damaging paintwork. |
| –
| The cut surfaces do not require additional cleaning. |
Note | Remaining material serves as adhesion base for newly applied adhesive sealing compound. |
| –
| The cleaning guidelines for surrounding components are to be observed → Chapter. |
| –
| New special attachments may be attached immediately at the prescribed positions with the adhesive points. |
| If the body part has been repaired or partially renewed, the area concerned must be cleaned and primed again after painting. |
WARNING | Exception: if bonding is performed later than one day after cutting back adhesive bead, the remaining residual material must be activated with activator -D 181 801 A1-. |
| Apply activator evenly in one stroke using applicator -D 009 500 25-. |
| Activator must not come in contact with paint, or the paintwork will be damaged. |
| Drying time approx. 10 minutes. |
|
|
|
|
