volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Sill mouldings and wheel housing trims > < Removing and installing steering column trim
Removing and installing sun visors
Removing and installing sun visors
  Note
Removal and installation is described for right side of vehicle. Follow same instructions for left side as appropriate.
Removing
–  Switch off ignition.
   
–  Unclip cover cap -2- using a small screwdriver.
–  Carefully pull sun visor bearing -1- out of mounting.
  Caution
Hold sun visor. Allowing the sun visor to hang on the wiring harness is not permitted!

   
–  Remove adhesive tape (used to minimise noise) and carefully disconnect connector -1- from sun visor -2- without pulling on flat cable.
Installing
  Note
Before installing, check fasteners for damage and renew if necessary.
–  Install in reverse order of removal.
–  Mask off connector to sun visor with adhesive tape to minimise noise.
  N68-10325

Sill mouldings and wheel housing trims > < Removing and installing steering column trim