Volkswagen Workshop Service and Repair Manuals

Removing and installing door trim panel (2-door models)   Note Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate. Removing –  Switch off ignition.

–	Remove bolt -1- on underside (4.5 Nm).

–  Models with manual adjustment of exterior mirror, unclip trim -1- from door trim using wedge -T10383/1-.

–  Models with electric adjustment of exterior mirror, unclip trim -1- from door trim using wedge -T10383/1- and disconnect connector.

–  Unscrew bolts -1- and -2- (4.5 Nm).

Caution When the door trim is separated, there is a risk that fastening elements may be damaged. To avoid this, always follow the specified order and positions of clips when removing the door trim.

–	Release door trim from clips in -specified sequence-. Use wedges -T10383- to do this.

–  Swivel rear area of door trim panel upwards slightly. –  Pull door trim panel out of window slot.

–  Now unhook Bowden cable -1- from interior door handle on inside of door trim. –  Depending on vehicle equipment, disconnect wiring harnesses from door trim. Installing   Note Before installing, check fasteners for damage and renew if necessary.

Caution Before installing door trim, ensure that the locking mechanisms of all clips are in -position 1-. It is not possible to install the door trim without problem if clips are in -position 2-!

–  Install in reverse order of removal.   Note t  When fitting door trim panel, first slide hook (front section of door trim panel) under front trim panel cover. t  Then push door trim panel into window slot seal and press into clips, working from top to bottom.