volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Bosch 8.2 ABS, right-hand drive > < Removing control unit and hydraulic unit

Polo Mk5

Installing control unit and hydraulic unit
Installing control unit and hydraulic unit
  Note
t  Remove sealing plugs from new hydraulic unit only when the corresponding brake line is going to be fitted.
t  If sealing plugs are removed too early from the hydraulic unit, brake fluid can escape, and it can then no longer be guaranteed that the unit can be sufficiently filled and bled.
t  When installing, ensure that rubber dampers are not pressed out of bracket.
–  Continue installation in reverse order.
–  Remove brake pedal depressor -V.A.G 1869/2-.
–  Bleed brake system → Chapter.
–  Code ABS control unit -J104- with → Vehicle diagnostic, testing and information system VAS 5051 in „Guided fault finding“.
–  Code radio.
   
Specified torques: 
Pin to hydraulic unit8 Nm
Hexagon nut to body20 Nm
Brake lines to ABS unit: 
Thread M10 x 114 Nm
Thread M12 x 114 Nm

   

Bosch 8.2 ABS, right-hand drive > < Removing control unit and hydraulic unit