volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing brake master cylinder > < Removing and installing brake light switchF, left-hand drive

Polo Mk5

Removing and installing brake light switchF, right-hand drive
Removing and installing brake light switch -F-, right-hand drive
Removing
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50.
   
–  Undo bolt -arrow B- of brake light switch -F--1- from brake master cylinder.
–  Pull brake light switch -F--1- out of brake master cylinder upwards.
–  Pull brake light switch -F--1- out of brake master cylinder locking lug -arrow A-.
–  Remove brake light switch -F- together with wiring.
–  Release connector of brake light switch -F- and pull it off.
Installing
Install in reverse order. Note the following points:
  N47-10184
–  Insert brake light switch -F--1- into brake master cylinder locking lug -arrow A-.
–  Screw in bolt -arrow B- and tighten.
  N47-10184
Specified torque
ComponentSpecified torque
Brake light switch -F- to brake master cylinder7 Nm

   

Removing and installing brake master cylinder > < Removing and installing brake light switchF, left-hand drive