Polo Mk5
1 - | Air duct* |
2 - | Climatic* heating regulation and air-conditioning system |
q | With built-in air conditioning system switch -E30- |
q | With fresh air blower switch -E9- |
q | With fresh air and air recirculation flap switch -E159- |
q | Removing and installing → Chapter |
3 - | Left and right side vents* |
q | Removing and installing → Chapter |
4 - | Centre vent* |
q | Removing vent → Chapter. |
5 - | Dash panel cross member* |
6 - | Heater and air conditioning unit |
q | Removing and installing → Chapter |
7 - | Fresh air blower series resistor with overheating fuse -N24-* |
q | Removing and installing → Chapter |
8 - | Fresh air blower -V2-* |
q | Removing and installing → Chapter |
9 - | Fresh air and air recirculation flap control motor -V154-* |
q | Checking: use vehicle diagnosis tester in „Guided fault finding“. |
q | Removing and installing → Chapter |
q | Renewing: initiate basic setting using vehicle diagnosis tester → Chapter. |
10 - | Flexible shaft* |
q | For air distribution flap actuator |
q | Removing and installing → Chapter |
11 - | Footwell vent, right* |
q | Removing → Chapter |
12 - | Dust and pollen filter* |
q | With activated charcoal filter |
q | Removing and installing → Chapter |
13 - | Connecting piece* |
14 - | Rear duct* |
q | Removing and installing → Chapter |
15 - | Rear duct vent* |
16 - | Temperature flap control motor -V68-* |
q | Checking: use vehicle diagnosis tester in „Guided fault finding“. |
q | Removing and installing → Chapter |
q | After renewing: initiate basic setting using vehicle diagnosis tester → Chapter. |
17 - | Footwell vent temperature sender -G192-* |
q | Checking: use vehicle diagnosis tester in „Guided fault finding“. |
q | Function: controls the air distribution of defroster function/ footwell and the fresh air blower speed dependent upon the vent temperature. |
q | Emergency running in event of failure: continued operation assuming coolant temperature of +80 °C. |
q | With seal. |
q | Removing and installing → Chapter |
18 - | Footwell vent, left* |
q | Removing → Chapter |
19 - | Centre vent temperature sender -G191-* |
q | Checking: use vehicle diagnosis tester in „Guided fault finding“. |
q | Function: controls the air distribution of defroster function/ footwell and the fresh air blower speed dependent upon the vent temperature. |
q | Emergency running in event of failure: continued operation assuming coolant temperature of +80 °C. |
q | With seal. |
q | Removing and installing → Chapter |
20 - | Evaporator output temperature sender -G263-* |
Note
There are two different types of evaporator output temperature sender -G263-. The removal and installation is identical for both types. |
q | Checking: use vehicle diagnosis tester in „Guided fault finding“. |
q | Removing and installing → Chapter |
21 - | Gasket between heat exchanger and plenum chamber bulkhead |
q | Note installation position → Fig.. |
22 - | Gasket between evaporator housing and plenum chamber bulkhead |
23 - | Dash panel* |
q | Removing and installing → Rep. gr.70 |