Polo Mk5
Dismantling and assembling heater unit |
1 - | Heater unit wiring harness |
2 - | Upper part of housing |
3 - | Bracket |
q | Bolted to cross member and heater unit |
4 - | Fresh air blower series resistor with overheating fuse -N24- |
q | Removing and installing → Chapter |
5 - | Air intake housing |
q | With fresh air and air recirculation flap |
6 - | Seal |
7 - | Lower part of housing |
8 - | Fresh air and air recirculation flap control motor -V154- |
q | Removing and installing → Chapter |
9 - | Control motor bracket |
10 - | Fresh air blower -V2- |
q | Removing and installing → Chapter |
11 - | Fresh air blower housing |
12 - | Dust and pollen filter cover |
13 - | Dust and pollen filter |
q | Removing and installing → Chapter |
14 - | Air distribution flap actuator |
q | Removing and installing → Chapter |
15 - | Distribution box, lower part |
16 - | Auxiliary air heater element -Z35- |
q | Only vehicles with a diesel engine. |
q | Checking → Chapter |
q | Removing → Chapter |
17 - | Heat exchanger |
q | Removing and installing → Chapter |
Note
After renewing heat exchanger, renew coolant completely. |
18 - | Distribution box, upper part |
19 - | Temperature flap actuator |
q | Removing and installing → Chapter |