volkswagen Workshop Repair Guides

Volkswagen Polo Workshop Service and Repair Manuals

ABOUT US
Installing > < Renewing seal and sleeve together (one-piece seal and sleeve for right flange shaft)

Renewing Right Flange Shaft Seal and Sleeve: Removal

Removing
Removing
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50.
–  Turn steering to right to full lock.
   
–  Remove drive shaft heat shield, if present -arrows- → Running gear, axles, steering; Rep. gr.40.
–  Unbolt drive shaft from flange shaft.
–  Raise drive shaft as high as possible and secure. Take care not to damage paint on drive shaft in the process.
–  Unbolt turbocharger oil return line from engine → Rep. gr.21.
–  Place drip tray under gearbox.
  N34-11369
–  Remove flange shaft securing bolt by screwing two bolts into flange and counterholding flange shaft with a lever.
–  Pull out flange shaft with compression spring.
  V34-2737
–  Pull out seal and sleeve together.
There is a shoulder in the inner diameter of the sleeve.
–  Apply puller hooks -VW 771/37- directly behind shoulder in sleeve.
–  Press extractor hooks -VW 771/37- forcefully into sleeve while pulling.
  N39-1187

Installing > < Renewing seal and sleeve together (one-piece seal and sleeve for right flange shaft)