volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing clutch pedal with extension spring, Polo 2010 ? LHD

Polo Mk5

Removing
Removing
–  Remove driver side trim → General body repairs, interior; Rep. gr.70.
–  Remove footwell vent → Heating, air conditioning; Rep. gr.80.
   
–  Remove crash bar -arrow-.
–  Remove clutch pedal switch -F36- → Chapter.
–  Unhook extension spring.
  N30-10225
Right-hand part of figure -arrows- only applies to installation.
  N30-10226
–  Release master cylinder operating rod from clutch pedal as follows:
–  Pull clutch pedal gently into passenger compartment.
–  Press sides of retainer inwards -arrows- using pliers -T10005-.
  N30-0280
–  Remove bearing shaft for clutch pedal.
–  To do this, turn bearing shaft for clutch pedal to left -direction of arrow-.
-1- = Allen key, 8 mm AF.
Locking devices -A- are irreparably damaged.
Pins -B- are then horizontal.
–  Move clutch pedal so you can pull out bearing shaft.
–  Remove clutch pedal.
  N30-10227

Installing > < Removing and installing clutch pedal with extension spring, Polo 2010 ? LHD