volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Topping up ATF > < Checking ATF level and topping up

Polo Mk5

Checking ATF level
Checking ATF level
   
–  Switch off engine.
  N34-10476
The ATF temperature should not be more than approx. 30° C at the start of the test.
l  Gearbox not in emergency running mode, ATF temperature not above approx. 30° C
l  Vehicle must be standing level
l  Selector lever in „P“.
–  Connect »tester« and continue switching until it is ready for operation → Chapter.
–  Press Guided functions on »right«.
–  Then select vehicle and gearbox Check ATF level.
–  Press →.
–  Start engine.
–  Raise vehicle.
–  Place drip tray under gearbox.
–  Press →.
If a test temperature between 35 °C and 45 °C is displayed:
  N01-0453
–  Remove inspection plug for ATF level from oil pan -arrow-.
  N37-0189
The ATF present in the overflow pipe runs out.
If ATF drips out of drilling:
ATF does not need topping up.
–  Fit new seal to plug and tighten to 27 Nm. This concludes the ATF check.
If no ATF drips out of inspection hole:
–  ATF must be replenished → Chapter.
  N37-0992

Topping up ATF > < Checking ATF level and topping up